7
Installation
1. Align the Ceiling Mount Assembly directly over
where the S50 will be suspended, between two
joists in the ceiling as shown in Figure 5.
To better line up the ceiling mount with the nal
location of the S50, a string with a small weight at-
tached can be slowly dropped through the center of
the Ceiling Mount Assembly.
2. Secure the Ceiling Mount Assembly to the joists
once the nal location has been determined.
3. Working from the ceiling downwards, begin attach-
ing sections one-by-one to create the full suspen-
sion structure.
*NOTE: One structure section should be set aside
to attach to the S50.
Each section will come packaged with four (4) joint
plates that are used to secure the sections together.
Use the included fasteners to attach the sections
together as shown in Figure 6.
4. As sections are attached, slide vent pieces through
the center of the structure and attach to any other
existing vent pieces. (See picture in next page)
Keep the very top piece unattached for the time
being as it will need to attach to the unit once it has
been secured to the suspension structure.
5. Continue attaching suspension structure and vent-
ing pieces until there is only one suspension struc-
ture piece left (set aside at a previous step)
Ceiling Mount installation
18”
(457mm)
18”
(457mm)
Figure 5: Ceiling Mount Attachment
Figure 6: Suspension Structure Attachment - Ceiling
A qualied engineer or architect MUST sign o on the structure supporting the hanging kit
prior to installation. Maximum total system weight is 400lb.
To Next Page
Loading...
