User Manual
Gobi-640-17µm and Gobi-384-25µm-GigE, CL, CXP Camera
1.2. Manual Overview
This section provides a chapter overview:
• Chapter 1 gives an overview of the conventions used in this manual (styles and
symbols), the safety warnings, conformity information about Xenics cameras and
the contact information.
• Chapter 2 gives a mechanical (2D drawings) and electrical overview
• Chapter 3 describes the optical interfaces
• Chapter 4 describes the electrical interfaces
• Chapter 5 provides the installation of the Xeneth and SDK software
• Chapter 6 lists the steps to get started using the camera
• Chapter 7 lists the appendices.
1.3. Reference Documents
(Ref. 1) Xenics Serial Protocol ENG-2011-ICD003
(Ref. 2) Mechanical Drawing Gobi-640-GigE
Mechanical Drawing Gobi-640-CL
(Ref. 3) Auto Gain Control ENG-2013-UMN006
(Ref. 4) Histogram Equalization ENG-2014-UMN002
(Ref. 5) Bolometer Control & Operation ENG-2013-ICD004
(Ref. 6) Network connection set-up for GigE ENG-2013-ICD003
(Ref. 7) Frame rate calculator ENG-2013-ICD012
(Ref. 8) Xeneth Installation Manual (see Xeneth SW directory)
ENG-2013-UMN024
1.4. Conventions Used in This Manual
To give this manual an easily understood layout and to emphasize important information,
the following typographical styles and symbols are used:
The styles used in this manual are:
• Bold: used for programs, inputs (commands or parameters) or highlighting
important things
• Courier New: used for code listings and output.
• Italics: used for modes and fields.
The symbols used in this manual:
Note: This symbol highlights important information.
www.envision.co.kr •Supporting your Vision
(주)앤비젼 서울시 금천구 가산동 550-1 IT캐슬 1동 603호 (153-768)
Tel. 02. 2624. 5503 Fax. 02. 2082. 6427 e-mail. sales@envision.co.kr
To Next Page
Loading...
Need help?
General