Need help?Do you have a question about the EO Genius and is the answer not in the manual?
General| Brand | EO |
|---|---|
| Model | Genius |
| Category | Automobile Accessories |
| Language | English |
Steps required before hardware installation, including portal access and host creation.
Steps for removing the charger, base plate, and preparing for mounting.
Instructions for cutting holes, fitting glands, and connecting power cables.
Key details on power supply, environment, mounting, and charging mode for the EO Genius.
Connecting the serial cable to the EO Hub's RJ45 connector using appropriate cables and connectors.
Wiring connections for multiple EO Genius units to the serial bus and EO Hub.
Proper use and placement of 120-ohm terminating resistors for reliable RS485 communication.
Guidelines for fitting CT clamps for automatic load management, including orientation.
Requirements for internet connection, firewall ports, and IP address configuration for the EO Hub.
Connecting the EO Hub using a GSM 4G modem when a client network is unavailable.
Understanding the EO Hub's boot-up sequence and interpreting the status of its LEDs.
Interpreting the LED colors and states for power up and normal operation of the EO Genius charger.
Procedures for starting, stopping charging sessions, and recommended cleaning practices.
Information on where to find technical documentation and how to contact the EO Support team.
To Next Page
