ep CQD20 - Run the Truck; Checking and Preparing; Adjusting the Drivers Seat

18
Item
Component
Function
1
Steering display area
Steering angle display in arrow form.
2
Power display area
Battery discharge status and energy recovery display.
3
Information display
area
Warning and fault indication and data registration
4
Height display area
Real time display of fork height
5
Steering fault alarm
zone
When the steering system when problems arise, the symbols will
appear.
6
Driving fault alarm zone
When the driving system when problems arise, the symbols will
appear.
7
Hydraulic fault alarm
zone
When the hydraulic system when problems arise, the symbols will
appear.
8
Low battery alarm zone
When the electricity is too low, the symbols will appear.
3.3 Run the truck
3.3.1 Checking and Preparing
Checks and operations to be performed before starting daily work
• Visually inspect the entire truck (in particular wheels and load handler) for obvious
damage.
• Visually inspect the battery attachment and cable connections.
• Check the load handler for visible damage such as cracks, bent or severely worn
load forks.
• Test the warning device.
• Make sure the load chains are evenly
tensioned.
• Check whether the normal function of all
safety devices.
3.3.2 Adjusting the driver’s seat
To avoid risk to health and property, check and adjust the individual driver’s seat
setting before starting up the truck. The driver’s seat must be occupied in order to
adjust to the driver’s weight.
Warning!
Before the truck can be
commissioned, operated or a load unit
lifted, the driver must ensure that there
is nobody within the hazardous area.