ep F4 - Key Switch and Display Instrument; Key Switch; Display Instrument

REV. 09/2021
7
B
1.2.4 Display instrument
Pulling out the key switch of a forklift
before leaving can prevent the forklift from
starting accidentally.
i
NOTE
1.2.3 Key switch
Key switch
Connect and interrupt control current.
• When the key rotates to gear “OFF”, the
control current of the truck will be interrupted;
• When the key rotates to gear “ON”, the control
current of the truck will be connected.
When the truck is started, the four light
indicator will light up. When the only
residual light indicator (4) is ashing, it
means that the truck capacity is low and it
should be charged immediately. Otherwise
the truck will be power o󰀨.
Low Voltage Protection
The car has low voltage protection
function.
When the battery power of forklift truck is
7%-15%. At this time, the truck can not lift
goods, but it can run normally. When the
battery power is less than 7%. At this time,
the truck can not be lifted and the driving
speed becomes slower.
i
NOTE
4
3
2
1
It is normal that the light indicator will still
be on when the key switch is turned o and
the supply plug is not pulled out.
NOTE
i
Fig0000-00098OM
Fig1154-00002OM