ep F4 - Operating Without Drive System

REV. 10/2021
22B
1.3.12 Operating the truck without its own drive system
If the truck has to be moved after a failure has
rendered it immobile, proceed as follows:
Pull ou the supply plug.
Set the key switch “OFF” and remove the key.
Prevent the truck from rolling away.
Remove the cover.
Screw in two screws(1), M4*35mm until the
truck can be moved (no braking action).
After setting down the truck at the destination,
unscrew two screws(1)
.
Braking action is restored.
•
•
•
•
•
•
This operating mode is not permitted when
negotiating inclines and gradients.
WARNING
Fig0000-00067OM