ep F4 - Page 40

REV. 10/2021
4
D
Error code LED BLINKS Explanation
Possible cause
4
，
13
（
4,3
）
□□□□ □□□
EEPROM
fault
EEPROM failure or fault.
60
（
4,4
）
□□□□ □□□□
Motor Open The motor did not connect
69
（
4,5
）
□□□□ □□□□□
TEMP Sensor The temperature sensor is
disconnected or short-circuited.
12
（
5,1
）
□□□□□ □
EMCY STOP The emergency stop button being
pressed was detected.
130
（
5,2
）
□□□□□ □□
SRO SRO
failure.
Before power-on, the lift button
be pressed. After the fault is
show, walking is not a󰀨ected, but
the lifting is prohibited.
Release the lift button and power
on the device again.
i
NOTE
*LED ON: When there is no failure, the LED indicator is on.
*LED OFF: The controller is not powered on.