REV. 09/2022
21
B
1.3.11 Operating the truck without its own drive system
If the truck has to be moved after a failure has
rendered it immobile, proceed as follows:
• Press emergency stop switch .
• Set the key switch “OFF” and remove the key.
• Prevent the truck from rolling away.
• Remove the front cover(see chapter D
section1.3.2).
• Tighten two screws (1) until the truck can be
moved (no braking action).
• Set the emergency stop switch “ON”.
• Set the key switch “ON”, which the truck
powered all the time.
• After setting down the truck at the destination,
unscrew two screws (1).
Braking action is restored!
This operating mode is not permitted when
negotiating inclines and gradients.
WARNING
1
Inoperative trucks movement after brake
release must ensure that the power of
the truck is on or risk damaging the truck
controller.
NOTE
To Next Page
Loading...
