ep RPL201 - C Battery Use and Maintenance; Battery Charging; Precautions

REV. 09/2022
1C
Battery use and maintenance
C
1.1 Battery charging
1.1.1 Precautions
i
NOTE
• Charging the batteries shall only be carried out in adequately ventilated rooms and e.g. not in the
o󰀩ces or break rooms for equipped with lead-acid battery truck.
• Avoid the existence of any metal object in the surface of the lithium-ion battery;
• Do not pierce the battery case with nails or other sharp objects.
• Do not short-circuit the battery with wires or other metal objects!
• The plug connection parts should be inspected in terms of obvious damages before charging;
• Fire-ghting equipment must be kept in the charging place;
• Before charging, check if there is damage on cable connection and plug connection pieces.
• Do not use irregular charging sockets;
• The net height of the charging area shall be higher than 5m, and the safe distance from other
areas shall be greater than 5m. Charging in non-charging area is prohibited;
• No inammable substances or spark-generating materials being present or stored within a
distance of 2 metres of the truck parked for battery charging.
• No smoking or open re around when charging.
• When charging, do not wrongly connect the battery polarity, otherwise it may damage the battery.
• Please charge the lithium-ion battery at an ambient temperature of 0
℃
to 40
℃
.Do not charge
the lithium battery below 0
℃
.
• The safety provisions related to the lithium-ion battery and the manufacturer of charging station
must be strictly abode by.
The workplace regulations must be observed (emergency exits, escape routes, trac routes,
...) must be kept clear.
Intermediate charging
Lithium-ion battery systems o󰀨er the advantage that they can be recharged temporarily, allowing
industrial trucks to be charged at any time. As a result, shorter charging times can usually be
achieved and charging with higher currents is also possible.