Epilog Laser FusionPro 16000 User Manual

8. Select the Registration icon at the bottom of the process, since this process will be used only to
identify which circles are registration marks. It will not be processed as a vector.
9. The Dashboard will then prompt you to send the job to the Job Manager to continue. Click “Send to
JM” at the bottom of the screen and the Job Manager should open.
Setting Up the Job in the Epilog Job Manager
1. Place your item to be cut on the laser’s table.
2. Focus the table to your item.
- 122 -
SECTION 8: SYSTEM FEATURES

Epilog Laser FusionPro 16000 Specifications

General

Brand	Epilog Laser
Model	FusionPro 16000
Category	Engraver
Language	English