Epilog Laser FusionPro 16000 User Manual

Removing the Pedestal from the Fusion Pro
The Fusion Pro 48 is capable of fitting through a standard 36” door once its pedestal is removed. In some
cases, you may need to remove the pedestal from the Fusion Pro in order to place it in a desired location.
Note: Please read all of the steps below in full before beginning this task. You will need around
4-5 people to complete certain steps. Make sure all exhaust vents are removed from the back
of the machine and the machine is unplugged before you begin.
1. Position the machine in an open space on the floor. Place the foam pads from the shipping crate
on the floor behind the machine.
2. With the caster feet in the up position, roll the machine backwards so the caster wheels face the
front of the machine and the rubber feet are positioned toward the rear of the machine.
- 166 -
SECTION 10: SYSTEM MAINTENANCE

Epilog Laser FusionPro 16000 Specifications

General

Brand	Epilog Laser
Model	FusionPro 16000
Category	Engraver
Language	English