Safety and operating instructions
© Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
11
The drilling auger can be used to a depth of 30m (99ft)
under water. Contact the authorized Customer Center /
Dealer in your area if bigger water depth is required.
2.4 Use other than intended
Misusing the drum cutter or the boom can lead to dan-
gerous situations.
• Do not use the drum cutter in areas with a risk for
explosions.
• Do not cut any materials other than those mentioned
in chapter Intended use.
• Do not carry out any impacting work.
• Do not operate the drum cutter if picks are broken.
• Do not use the drum cutter as a device for lifting
people or materials.
• Do not use the drum cutter as a surface for carrying
or transporting machines, materials or tools.
• Do not use the drum cutter to take the weight of the
carrier.
Claims of any kind as a result of damages arising from
misuse are excluded.
2.5 Protective equipment
Personal protective equipment must comply with the ap-
plicable health and safety regulations.
Always wear the following personal protective equip-
ment:
• protective helmet
• safety glasses with side protectors
• protective gloves
• protective shoes
• warning vest
• Light respiratory protection
• Protective work clothing
Protective work clothing is tight-fitting work clothing with
low resistance to tearing, with tight sleeves and without
projecting parts. It is primarily used to protect against en-
tanglement by moving machine parts. Do not wear rings,
chains or other jewellery.
2.6 Carrier, precautions
WARNING Falling carrier
If the load-bearing capacity of the carrier used is insuffi-
cient, the carrier will not be stable. It can topple over and
cause injuries and damage.
Using a carrier whose load-bearing capacity is too high
will greatly burden the hydraulic attachment causing it to
wear faster.
u Only attach the hydraulic attachment to a hydraulic
carrier of a suitable load-bearing capacity.
u The carrier must remain stable at all times.
u Read the carrier manufacturer's Safety and operating
Instructions before attaching the hydraulic attach-
ment to the carrier and operating it. Observe all in-
structions.
NOTICE Damage to the hydraulic attachment
Working with a hydraulic attachment mounted to a long
reach boom may cause damage to the hydraulic attach-
ment.
u Before working with a hydraulic attachment mounted
to a long reach boom consult the Epiroc Customer
Center / Dealer in your area.
2.7 Transport, precautions
WARNING Risk of death due to suspended loads
When lifting loads these can swing out and fall. This can
result in serious injuries or even death.
u Never stand underneath or in the swinging range of
suspended loads.
u Only move loads under supervision.
u Only use approved lifting equipment and lifting gear
with sufficient load bearing capacity.
u Do not use worn lifting gear (ropes, belts, chains,
shackles etc.).
u Do not place lifting gear such as ropes and belts on
sharp edges or corners, do not knot these or twist
them.
u When leaving the workplace, set down the load.
WARNING Injury due to swivelling load
When transporting the load by crane it can swivel and
cause severe injuries and considerable damage to prop-
erty.
u Ensure that no personnel, objects or obstacles are
located in the swivel range of the load.
To Next Page
Loading...
General