Safety and operating instructions
© Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
17
3.3 Modules
Cutter drum
The longitudinal drum cutter is equipped with a cutter
drum driven by the drive shaft.
ER 100 L - ER 2000 L:
The cutter drum is fastened directly to the drive shaft
with screws and special clamping sleeves.
ERL 700, ERL 1100:
The cutter drum is attached via a hexagonal connection
to the output shaft and fixed with locking screws(H).
A certain number of pick boxes are attached to the sur-
face of the cutter drum. These hold the round attack
picks in position.
Transport lug
The transport lug(G) serves as an anchor point for the
lifting gear when transporting the drum cutter.
The transport lug is an eyebolt and can be unscrewed
after transportation. After removal of the transport lug the
thread must be protected from dirt and damage by a
blank plug.
Drive, hydraulic motor, intermediate bracket
The drum cutter is fastened to a suitable adapter plate
on the carrier boom via the intermediate bracket(A). The
intermediate bracket is bolted to the adapter plate.
The drive(B) carries the cutter drum. The hydraulic mo-
tor transfers the drive moment through the drive shaft to
the cutter drum.
Oil drain/filling plug
Actual details may differ.
The screw/screws is/are used for draining, filling and
venting the drive while changing gear oil.
To Next Page
Loading...
General