Safety and operating instructions
18 © Anbaufräsen PC GmbH | 3390 5221 01 | 2020-09-07
Original Instructions
Round attack picks
The round attack picks are made of steel and have a
brazed tungsten carbide tip. The round attack picks are
held in the pick boxes.
The appearance of the round attack picks may deviate
from the image shown here.
Pick boxes
The pick boxes are welded onto the cutter drums for
holding round attack picks. Some pick boxes may have a
wear sleeve, which can be exchanged.
Drilling auger
The drilling auger(C) can be mounted on the longitudi-
nal drum cutter as an accessory part. To do so the cutter
drum must be disassembled and the drilling auger
mounted onto the drive shaft via appropriate auger
adapter(B) . In addition, a pivot adapter(A) is mounted
between the carrier stick and the intermediate bracket.
The complete drilling auger has a drilling head(D) to
loosen the material and the auger removes the soil from
the bore hole.
Pivot adapter
The pivot adapter is an accessory part. The swivel
adapter must always be mounted when using the op-
tional drilling auger. This swivel adapter enables the
drilling auger to be aligned vertically and relieves the drill
drive of inadmissible bending forces.
To Next Page
Loading...
General