Epson 1390 - The Using Way to the Bulk Coat

Flatbed Inkjet Printer
１８
１８
Note：the “coat” be canned is with brume technology we can have direct spray to the surface
of the media. for the bulk type, please use brush & dipping way to use it。
b．The Using way to the Bulk Coat (one)：
1．Empty the bulk coat to the container。
2．Use the brush of the printer to dip the coat, brush the surface of the media by even speed, you
should keep the brush with uniform power, and please do not dip too much liquid on the brush, and,
don’t make too much coat on the brush, try the best to make it work even & not imprint obvious.
3．When the coat smear job be done, we need to have the fast dry, and you can use it by a dryer。
c．The Using way to the Bulk Coat (two)：
1．Empty reasonable volume coat liquid to the vessel, put the surface of printing media to the coat of
the vessel, and please have careful touch the printing surface with the coat.
2．After touching the coat, please take up the media & let the coat redundant flow back to the
vessel,(image left) if there have coat unused, please use napkin to take it away(image right)。