Epson 1390 - Pump Depose Ink

Flatbed Inkjet Printer
６
６
3. Pump depose ink
Open the depose ink protecting windows, please take the depose ink duct from the ink bottle,
connect it with the Injector, (please notice that the cartridge should be in position initialized), draw
back the injector and keep it with less volume ink in the injector, after this, please recover the
depose Ink duct back to the depose ink bottle.
When we finished the all course, please press the key “cleaning” to clean print-head. (You can
also do this step by software with clean function on computer)。
Note：
1．When we pump ink, there might have problem of speeding ink, it is indicating that the ink
bursa was damaged, please replace it.
2．During pump ink, if there with air seeping situation, and it could not pump ink good, it is
indicating there were not with good performance be sealed to the cleaning system, we need
to exchange the protector about print-head.
3．There might have “siphon” situation be happened in the transmission pipe of the printer, please
kindly have cleaning job to the printer after pump the depose ink.
4．For indicating the color of the ink, we have mark it with sign as below:
Cyan（blue）— C、Magenta（Red）— M、Yellow— Y、Black— K、
Light Cyan（Light Blue）— LC、Light Magenta（Light Red）— LM
Warn