Flatbed Inkjet Printer
７
７
1．When you inject ink to the printer, please according the seriation No. on the bottle of the printer,
avoiding dust & eyewinker to pollute the printer, please do the course in short time, unless, the
dust & eyewinker might block the print-head。
2．The ink which be applied by this printer is special for LOGE Series flatbed printer，please do not
use it for the other printer, and, please do not use the other brand ink for this printer, unless, it
might have damaged to this printer.
3．For storage to the ink, with protection idea, please make it with good seal, avoiding it close to high
temperature & fire. Please don’t burn the scrap ink & do not empty it to cloacae avoiding have
pollution to the living conditions. During application, When the ink taint with skin, please wash it
by Clearwater, if it has spatter to eyes, please also have cleaning by clear water, severe,
please contact with doctor, also, for better placement, please leave the ink to the place with child
could not reach.
E．Install Driver to the printer
Use the USB Cable to connect computer with
printer. Switch on the printer to enter standby status, insert the CD to the CD-ROM of the computer.
Click <Start>, select <Run>.
Input the Driver label of CD-ROM and setup.exe, click <browse> & select Setup.exe and
Press <Enter> key.
After, the printer will display “printer installation indication” ,please select “printer installation
indication/application tools”, program will automatic perform installation.
Note：Suggest use USB cable to connect
with printer, because it will obvious enhance the printing speed, if communicate by parallel port,
please shut off the power for the printer, unless, system might be damaged.
By now, the all course of installation to driver for printer would be finished, and you
can start to use the printer now。
CHAPTER TWO: USE PRINTER
A． The scheme of operation to the printer.
Note：before operating this printer, you should understand the all course of operating to this
printer。
To Next Page
Loading...
