Epson AcuLaser MX20DN series - Send Report; Detail Settings; Pause Time

Send Report
Specifies settings for the sent fax report. When On is selected, a report is printed every time a fax is sent.
When Error Only is selected, the printer prints a report only if a fax fails to transmit. The report is not
printed when faxing to multiple addresses.
Multi Send Report
Specifies settings for the multi-address transmission report. When On is selected, a report is printed
after all transmissions are completed. When Error Only is selected, a report is printed if one or more
errors occur during the transmission.
Detail Settings
Basically do not change the following settings.
Item Settings (default in bold)
Pause Time
*1
Long, Medium, Short, Other
Line Property
1, 2
Tone Time
*1
Long, Medium, Short, Other
Tone Interval
*1
Long, Medium, Short, Other
V.34 Function
On, Off
Reception Level 1
*1 *2
High, Medium, Low, Other
Reception Level 2
*1 *3
High, Medium, Low, Other
Transmission Level
*1
High, Medium, Low, Other
Transmission Reprt
On, Error Only, Off
*1
The default setting varies depending on the country where you use the printer.
*2
Available only when Incoming Mode is set to Auto Switching, Fax Only, or Phone Only.
*3
Available only when Incoming Mode is set to TAM.
Pause Time
Specifies the pause time when pause symbols are entered for a fax number.
Epson AcuLaser MX21/MX20 Series User's Guide
Using the Control Panel 168