Epson AcuLaser MX20DN series - Using the Postscript Printer Driver with Macintosh; Installing the Postscript Printer Driver; Selecting the Printer

Using the PostScript printer driver with Macintosh
Installing the PostScript printer driver
Note:
Make sure that no applications are running on your Macintosh before installing the printer driver.
For Mac OS X users
Note:
Make sure that Print & Fax (for Mac OS X 10.5 or later) or Printer Setup Utility (for Mac OS X 10.4 or
below) is not open.
1. Insert the printer Software Disc into your CD-ROM drive.
2. Double-click the CD-ROM icon.
3. Double-click Adobe PS, then double-click PS Installer.
4. The Install EPSON PostScript Software screen appears, click Continue, then follow the on-screen
instructions.
5. Easy Install is displayed on the screen. Click Install.
Note:
For Mac OS X 10.4 or below, if the Authenticate window appears, enter the user name and password
for an administrator.
6. When installation is done, click Close.
Selecting the printer
After installing the PostScript 3 printer driver, you need to select the printer.
In a network environment
For Mac OS X users
Note:
❏ Although EPSON FireWire appears in the interface pop-up list, you cannot use FireWire for printer
connection in the PostScript 3 mode.
Epson AcuLaser MX21/MX20 Series User's Guide
About the Printer Software 268