1. To draw a marquee, move your cursor over a preview image. The pointer becomes a set of
cross-hairs.
Note:
If you only have one photo on the document table, you can click the
auto locate icon to
automatically draw a marquee, then skip to step 3.
2. Position the pointer in the area where you want to place the corner of your marquee and click.
Hold down the mouse button and drag the cross-hairs over the image to the opposite corner of the
desired scan area. Then release the mouse button. You see the moving dotted line of the marquee.
3. Do one of the following to adjust the marquee.
❏ To move the marquee, position your cursor inside the marquee. The pointer becomes a hand.
Click and drag the marquee to desired location.
Epson AcuLaser MX21/MX20 Series User's Guide
Scanning 86
To Next Page
Loading...
