82
Troubleshooting
The drive cannot be used. Is use of the drive stopped?
When a write error occurs based on a preset write retry count, use of the
drive is automatically stopped, and [Drive operation paused DRV1/2] is
displayed on the LCD. See “Output device settings” on page 33 in this
guide for the drive use restarting procedure.
Head cleaning does not work. Has an error occurred in the product?
If an error has occurred, clear the error.
Is there enough ink?
Head cleaning cannot be performed unless there is enough ink. Replace
with a new ink cartridge.
See “Changing the ink cartridge” in the PP-100N User’s Guide for the ink
cartridge changing procedure.
The printing speed slowed
down during continuous
printing.
When printing is performed for an extended period of time, disc transfer
and printing may be stopped temporarily. This is for slowing the printing
speed to prevent overheating and damage to the product.
Although printing can be continued when this occurs, it is recommended
that you stop product operation and leave it with the power on for about
30 minutes. (The product will recover after about 3 hours with the power
off.)
Cannot publish discs. See “When discs cannot be published” on page 85 in this guide.
Symptom/Problem Status Check/Remedy Procedure
To Next Page
Loading...
