35
Installing the Wireless LAN Module
To use the projector over a wireless network, install the Epson 802.11b/g/n wireless LAN module in the
projector. Do not install any other type of wireless module.
Note: The wireless LAN module is not included with your projector and is optional.
1. Turn off the projector and unplug the power cord.
2. Insert the wireless LAN module into the USB-A port.
3. Plug in and turn on the projector.
The light on the wireless LAN module turns on when the module is installed and operating. The light
flashes when the module is communicating over the network.
Caution: Never remove the module while its indicator is blue or flashing, or while you are projecting
wirelessly. This could damage the module or lose data.
Parent topic: Wireless Network Projection
Selecting Wireless Network Settings Manually
Before you can project from your wireless network, you must select the network settings for the projector
using its menu system.
1. Turn on the projector.
2. Press the Menu button.
3. Select the Network menu and press Enter.
4. Make sure the Wireless LAN Power setting is set to On.
5. Select Network Configuration and press Enter.
6. Select the Basic menu and press Enter.
7. Select the following basic options as necessary:
• Projector Name lets you enter a name up to 16 alphanumeric characters long to identify the
projector over the network.
• Remote Password lets you enter a password up to 32 alphanumeric characters long for
accessing the projector using Basic Control. (Default user name is EPSONREMOTE; default
password is the projector's serial number.)
To Next Page
Loading...
