56
• Front/Upside Down flips the image over top-to-bottom to project upside-down from a ceiling or wall
mount.
• Rear flips the image horizontally to project from behind a translucent screen.
• Rear/Upside Down flips the image over top-to-bottom and horizontally to project from the ceiling and
behind a translucent screen.
Note: You can change the projection mode using the remote control or by changing the Projection
setting in the Settings > Installation menu.
Changing the Projection Mode Using the Menus
Parent topic: Using Basic Projector Features
Related references
Projector Feature Settings - Settings Menu
Changing the Projection Mode Using the Menus
You can change the projection mode to flip the image over top-to-bottom and/or left-to-right using the
projector menus.
Note: You can also press and hold the A/V mute button on the projector remote control for about 6
seconds to flip the image upside-down.
1. Turn on the projector and display an image.
2. Press the menu button on the projector remote control.
3. Press the arrow buttons to select the Settings > Installation > Projection setting and press Enter.
4. Select the projection mode you want to use and press Enter.
5. Press the menu button to exit the menu or the return button to return to the previous screen.
Parent topic: Projection Modes
Related references
Projector Feature Settings - Settings Menu
Adjusting the Image Height
If you are projecting from a table or other flat surface and the image is too high or low, you can adjust the
image height using the projector's adjustable foot.
To Next Page
Loading...
