Epson CO-W01 - Setting the Screen Type

58
3. Select Settings > Installation > Image Shift to display the Image Shift screen.
4. Use the arrow buttons on the remote control to adjust the image position.
Note: You can shift the image diagonally by pressing any pair of adjacent arrow buttons on the
remote control.
5. Press return to close the Image Shift screen.
Note: The Image Shift setting is retained even if the projector is turned off; however, you need to
readjust the image position if you change the projector's location or angle.
Parent topic: Using Basic Projector Features
Setting the Screen Type
You can use the Screen Type setting to match the aspect ratio of the displayed image to the screen you
are using.
Note: This setting is unavailable when using the USB Display, USB or LAN input source.
Note: The Screen Type setting is not supported by the Message Broadcasting feature in the Epson
Projector Management software.
1. Turn on the projector and display an image.
2. Press the menu button.