a
• When Screen Fit detects more than two sides of a frame
inside the projection area, it adjusts to fit the detected frame.
For example, when projecting onto a wide screen in a small
room, you can make corrections by fitting the top and bottom
sides of the screen into the projected area.
• Screen Fit may not function correctly in dark rooms such as
rooms with the lights turned off. In this situation, try
performing Screen Fit again after turning on the lights.
• Because Screen Fit relies on a sensor, it may not function
correctly depending on the status of the projection screen (if
it is curved or patterned and so on) or if the room is open to
daylight. In this case, make the adjustments manually.
s "Correcting manually - manual H/V-Keystone -" p.38
Correcting Keystone Distortion
You can correct keystone distortion using one of the following methods.
• Correcting automatically
-Auto H/V-Keystone (EB-1776W only)
-Auto V-Keystone (EB-1771W/EB-1761W/EB-1751 only)
• Correcting manually (manual H/V-Keystone)
Manually correct distortion in the horizontal and vertical directions
independently.
• Correcting manually (Quick Corner)
Manually correct the four corners independently.
a
When you correct keystone distortion, the projected image may be
reduced.
Correcting automatically - Auto H/V-Keystone - (EB-1776W only)
When the projector detects any movement, for example when it is moved
or tilted, it automatically corrects vertical and horizontal keystone distortion
as well as the focus. This function is called Auto H/V-Keystone.
Adjusting Projected Images
37
To Next Page
Loading...
Need help?
General
Weight and Dimensions
