Submenu Function
Connection
Mode
Set the connection mode to use when connecting the projector
and a computer via a wireless LAN.
If you select Quick, a small network is created automatically by
the projector and computer. It is used with EasyMP Network
Projection. If SSID Auto Setting is set to On, the projector
becomes an easy access point; if it is set to Off, the network is
created in
Ad hoc mode
g
.
If you select Advanced, the connection is established in
infrastructure mode
g
through the access point installed.
SSID Auto Set‐
ting
If Connection Mode is set to Quick, when you set this to On, you
can search for the projector more quickly from among multiple
projectors. SSID is set automatically.
When connecting to multiple projectors from 1 computer in
Quick mode, set this to Off, and set the same SSID in all the
projectors that will connect.
SSID
Enter an SSID. When an SSID is provided for the wireless LAN
system in which the projector participates, enter the SSID.
You can enter up to 32 single-byte alphanumeric characters. Set
SSID to blank or ANY to establish an ANY connection.
Search Access
Point
When Connection Mode is set to Advanced, you can search for
surrounding access points, and set the SSID to be connected from
those access points. Depending on the access point settings, they
may not be displayed in the list. You must set security separately.
s "Search Access Point screen" p.101
Channel
You can select the channels used to connect in Quick mode. If
interference from other signals occurs, use a different channel.
SSID Display
To prevent the SSID from being displayed on the LAN Standby
screen, set this to Off.
DHCP
You can set whether or not (On/Off) to use
DHCP
g
.
If this is set to On, you cannot set any more addresses.
Submenu Function
IP Address
You can input the
IP address
g
assigned to the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used. 0.0.0.0,
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Subnet Mask
You can input the
Subnet Mask
g
for the projector. You can enter
a number from 0 to 255 in each field of the address. However, the
following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Ad‐
dress
You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
IP Address Dis‐
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Region Code
This is a specific string of the wireless LAN module.
List of Functions
100
To Next Page
Loading...
Need help?
General
