Submenu Function
Reset
You can reset all adjustment values on the Signal menu to
their default settings, except for Input Signal.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.109
Settings Menu
Submenu Function
Keystone
You can correct keystone distortion.
• When H/V-Keystone is selected:
Adjust V-Keystone and H-Keystone to correct horizontal
and vertical keystone distortion.
You can also set Auto H/V-Keystone to On or Off.
s
"Correcting Keystone Distortion" p.39
• When Quick Corner is selected:
Select and correct the four corners of the projected image.
s "Quick Corner" p.40
Submenu Function
Split Screen
You can split the screen into two screens.
You can change the Screen Size, and select the Source, Swap
Screens, Audio Source, and Exit Split Screen.
s "Projecting Two Images Simultaneously (Split Screen) "
p.54
Control Panel
Lock
You can use this to restrict operation of the projector's control
panel.
s
"Restricting Operation (Control Panel Lock)" p.69
Pointer Shape
You can select the shape of the pointer.
Pointer 1:
Pointer 2:
Pointer 3:
s "Pointer Function (Pointer)" p.59
Power Consump‐
tion
You can set the lamp brightness to one of two settings.
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the power consumption and the lamp's
operating life are changed as follows, and fan rotation noise
during projection is reduced.
Electrical consumption: about 25% decrease, lamp life: about 1.4
times longer
Volume
You can adjust the volume. Setting values are saved for each
source.
Remote Receiver
You can limit the reception of the operation signal from the
remote control.
When set to Off, you cannot perform any operations from the
remote control. If you want to make operations from the remote
control, hold down the [Menu] button on the remote control for
at least 15 seconds to reset the setting to its default value.
List of Functions
94
To Next Page
Loading...
Need help?
General
