Remote Control
Name Function
A
[t] button
Turns the projector power on or off.
s "From Installation to Projection" p.33
B
[Computer] button
Each time you press the button, the image displayed
changes between the Computer1, Computer2, and the
DisplayPort (EB-1965/EB-1955/EB-1945W/EB-1935
only) ports.
C
[Video] button
Each time the button is pressed, the image displayed
changes between the Video input port and HDMI input
port.
D
[Screen Fit] button
Adjusts the projected image so that it fits the screen frame.
s "Automatically adjust to fit into the screen frame -
Screen Fit" p.42
This button is disabled when the projector is suspended
from a ceiling or if the projector model does not support
this function.
E
Numeric buttons
• Enter the Password.
s "Setting Password Protect" p.67
• Use this button to enter numbers in Network settings
from the Configuration menu.
F
[Auto] button
If pressed while projecting analog RGB signals from the
Computer port, you can automatically optimize Tracking,
Sync., and Position.
G
[Aspect] button
Each time the button is pressed, the aspect mode changes.
s "Changing the Aspect Ratio of the Projected Image "
p.49
H
[Num] button
Hold down this button and press the numeric buttons to
enter passwords and numbers.
s "Setting Password Protect" p.67
I
[Menu] button
Displays and closes the Configuration menu.
s "Using the Configuration Menu" p.88
Part Names and Functions
17
To Next Page
Loading...
Need help?
General
