Check Remedy
Is Output audio from the projector selected?
(Only when projecting USB Display)
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
The remote control does not work
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Point the remote control towards the remote receiver.
s "Remote control operating range" p.20
Is the remote control too far from the projector? The operating range for the remote control is about 6 m.
s "Remote control operating range" p.20
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote receiver to
Off from Remote Receiver in the Configuration menu.
s Settings - Remote Receiver p.94
Is the correct setting for the Remote Receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.94
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
s "Replacing the remote control batteries" p.19
When adjusting color difference using the multi-screen color
adjustment function, have you specified the correct projector ID for
the projector you want to operate?
While holding the [ID] button, press the number button that matches the ID of the projector you want to operate.
s "Setting an ID and using the remote control" p.62
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the Language setting from the Configuration menu.
s Extended - Language p.95
Problem Solving
124
To Next Page
Loading...
