Setting the Projector
78
Batch Setup Function
After making the projector's menu settings for one projector, you can copy the settings to other projectors
(batch setup function). The batch setup function is only for projectors with the same model number.
Use one of the following methods.
•
Setup using a USB flash drive.
•
Setup by connecting the computer and projector with a USB cable.
•
Make settings using Epson Projector Management.
This guide explains the USB flash drive and the USB cable methods.
For details on making settings using Epson Projector Management, see the Epson Projector Management
Operation Guide.
c
•
If you do not want to copy the following settings, set Batch Setup Range to Limited.
•
Password Protection
•
EDID from the Signal I/O menu
•
Network menu
•
Perform batch setup before adjusting the position of the projectors. The batch setup function copies
adjustment values for the projected image such as Geometry Correction. If batch setup is performed
after adjusting the position of the projectors, the adjustments you made may change.
•
By using the batch setup function, the registered User's Logo is copied to the other projectors. Do not
register confidential information as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due to an accident such as a
power failure, communication error, the customer is responsible for any repair costs incurred.
Setup Using a USB flash drive
This section explains how to perform batch setup using a USB flash drive.
c
•
Use a FAT format USB flash drive.
•
The batch setup function cannot be used by USB flash drives that incorporate security functions. Use
a USB flash drive that does not incorporate security functions.
•
The batch setup function cannot be used by USB card readers or USB hard disks.
Saving settings to the USB flash drive
a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
To Next Page
Loading...
Need help?
General
