• Multi-screen display
s
p.22
You can use different projectors to project a single image as a
landscape screen allowing you to project long images such as reports.
• Presentation Mode
s
p.21
This function can project PowerPoint Slide Show running on a
computer. You can give stylish presentations by projecting a black
screen while making preparations and so on, and when not
performing a Slide show.
• Distribution function
The screen being displayed by a remote computer can be
simultaneously displayed by up to four projectors on the same network.
• Switching function
By using the meeting switching function, if EMP NS Connection is
installed on all of the computers, the presenters can take turns and
project their own images without changing cables.
Steps for Connecting in Advanced Connection
Mode
Use the following procedure to connect and project in EMP NS
Connection Advanced Connection Mode.
You need to perform steps 1 to 4 only the first time you connect.
1.
Install EMP NS Connection on the computer to be connected. s p.8
2. Make network settings on the computer and put it into network
connection status.
s
p.13
3.
Enable the Wired LAN adaptor at “Port Configurations”. s Computer's
documentation
4. Make network settings on the projector and put it into network
connection status. s User's Guide "Network Menu (EB-826W/825/85/84
only)"
5. Start EMP NS Connection on the computer and connect with the
projector.
s
p.14
* For 2 and 3, normally when a computer is connected with the network
and used, you do not need to make computer network settings.
EMP NS Connection Summary
12
To Next Page
Loading...
Need help?
General
