Operating the Projector
Before connecting, put the projector into connection standby status.
Make sure the projector network settings are complete, and the
projector is connected to network equipment such as a network hub via
a commercially available network cable.
Procedure
A
Press the [t] button on the Remote Control or the Control
panel to turn the power on.
B
Press the [LAN] button on the Remote Control.
The LAN standby screen is displayed.
Operating the Computer
In the following explanations, unless otherwise noted, Windows screen
shots are used. You see the similar screens even when using Macintosh.
Procedure
A
Start EMP NS Connection.
For Windows
Select Start - Programs (or All Programs) - EPSON Projector -
EMP NS Connection.
For Macintosh
Double-click the Applications folder of the hard drive volume in
which EMP NS Connection is installed, and then double-click the
EMP NS Connection icon.
B
Select "Advanced Connection Mode" and then click "OK".
The projector search results are displayed. To always connect
using Advanced Connection Mode, select Set the selected
Connection Mode as the default mode for future connections..
C
Select the projector you want to connect to, then click
"Connect".
If the projector you want to connect to is not displayed in the
search results, click the Automatic search button. The search
takes about 30 seconds.
For details on the connection screen, see Using the Connection
Screen.
s p.15
Connecting to a Projector on a Network and Projecting
14
To Next Page
Loading...
Need help?
General
