In the following explanations, unless otherwise noted, Windows screen
shots are used.
You see the similar screens even when using Macintosh.
Procedure
A
Click "Manual search" on the EMP NS Connection projector
selection screen.
B
Enter the IP Address or the Projector Name for the projector
you want to connect to, and click "OK".
The search results are displayed on the EMP NS Connection
projector selection screen.
Provided the target projector has been identified, select that
projector, and then click Connect to establish a connection.
When you will always be using that projector, save the search as
a Profile, so that you do not have to specify the relevant details
every time you perform a search.
s p.34
q
When you use Manual search in Quick Connection Mode, you can
specify the SSID. When there are a lot of projectors you can
narrow the search field by using SSID.
Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection Mode Only)
33
To Next Page
Loading...
Need help?
General
