When the system starts in Quick Connection Mode.
A
Automatic search
In Advanced Connection Mode, you can search for available
projectors on the network system that the computer is connected to.
In Quick Connection Mode, you can search for the projector based
on the SSID.
B
Manual search
In Advanced Connection Mode, you can search for a projector based
on a specified IP address or Projector name.
In Quick Connection Mode, you can search for the projector based
on the SSID selected from a list.
C
Status
The following six icons indicate the status of the detected projectors.
Standby Select for connecting.
Busy Select for connecting. When you click
Connect, the computer currently
connected is disconnected and your
computer is connected.
Busy (Disable
interrupt
connection)
Cannot be selected. Disable interrupt
connection is set on another computer
which is already connected.
Currently in
use by another
application
The projector's Configuration Menu is
open. You can select it after closing the
Configuration Menu and running the
search again.
Searching Displayed while running Manual search or
Profile.
Not found Displayed when a projector cannot be
found as a result of Manual search or
Profile. In Quick Connection Mode, you
can only select multiple projectors with the
same SSID.
D
Projector name
The projector's name is displayed.
E
Disable interrupt connection
Check the box to prevent an interrupt connection by other computers while
connected to the selected projector.
F
Use multi-display
Check the box to use the Multi-screen display function. When this is selected,
Display layout and Display properties are displayed at the bottom of the screen.
s p.22
G
Troubleshooting
If there is a problem and you cannot have a connection, press this button to
open the EMP NS Connection Troubleshooting screen.
H
Connect
Connect to the projector you selected from the search results list. When a
connection is made with a projector, a toolbar is displayed.
I
Set options
You can make general setting options such as the processing method when
EMP NS Connection starts. For details, see
s
p.39
J
Save in the profile
Saves the results of a search for projectors on the network as a Profile.
s p.34
Connecting to a Projector on a Network and Projecting
16
To Next Page
Loading...
Need help?
General
