Operations
a
Select Curved Surface from Geometric Correction.
b
Select Correct Shape.
c
Use the [ ], [ ], [ ], and [ ] buttons to select the corner you
want to adjust, and then press the [
] button.
When selecting a corner, you can adjust the two sides next to the
corner.
d
Use the [ ], [ ], [ ], and [ ] buttons to adjust the shape.
If the triangle in the direction you are adjusting the shape turns gray,
as shown in the screenshot below, you cannot adjust the shape any
further in that direction.
e
Press the [Esc] button to return to the previous screen.
f
Repeat procedures from 3 to 5 as needed to adjust any remaining
parts.
If the image expands and contracts, go to the next step and adjust
the linearity.
g
Press the [Esc] button, and then select Horizontal Linearity or
Vertical Linearity.
Select Horizontal Linearity to adjust the horizontal expansion or
contraction, and select Vertical Linearity to adjust the vertical
expansion or contraction.
Projecting Images
50
To Next Page
Loading...
