h
Select the standard line for the adjustments, and then press the
[
] button.
Use the [
][ ] buttons when selecting the Horizontal Linearity,
and the [
][ ] buttons when selecting the Vertical Linearity, and
then press the [
] button.
The selected standard line is displayed in flashing red and white.
i
Adjust the linearity.
Adjust so that the gaps between the lines are equal.
When the [
] is pressed
Selecting the Horizontal Linearity Selecting the Vertical Linearity
When the [ ] is pressed
Selecting the Horizontal Linearity Selecting the Vertical Linearity
a
You can fine tune the results of Curved Surface using Point
Correction. Change Geometric Correction to Point Correction, and
then make adjustments after selecting Keep the current geometric
correction settings.
s "Point Correction" p.59
Projecting Images
51
To Next Page
Loading...
