Submenu Function
s "Hiding the Image and Sound Temporarily (A/V
Mute)" p.107
Advanced: The following items can be set.
• BNC Sync Termination: Set the termination for the
signal from the BNC port. This should usually be set to
Off. Set to On when analog (75Ω) termination such as for
switchers is necessary.
• Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control
provided with this projector. When Simple is selected, you
can use the remote control provided with other Epson
projectors to operate this projector. This is useful if you
want to use a remote control that you are already familiar
with to operate the projector.
However, you cannot use the remote control provided
with this projector if this is set to Simple. Make sure that
the setting is correct because, if the projector is mounted
on the ceiling or somewhere hard to reach, changing it
back to Normal may be difficult. Additionally, you cannot
use the functions that are not equipped with this projector
or the remote control which you use.
• Beep: When this is set to On, the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
• Indicators: When set to Off, the projector's indicators are
turned off, except for abnormality or warning.
• Instant Off: When set to Enabled, the projector goes into
standby status in approximately three seconds after Power
Off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
command communication, set this to Disabled. When set
Submenu Function
to Disabled, the projector goes into standby status in
approximately 75 seconds after power off.
• Inv Direction Button: Set this to On when the projector
is installed on a ceiling.
• HDMI DDC Buffer: If the image from a device
connected using an HDMI extension cable is not
displayed correctly, turning this On may improve the
image.
• DVI-D DDC Buffer: If the image from a device
connected using a DVI extension cable is not displayed
correctly, turning this On may improve the image.
• Lens Type: When using the following lens, select the
model number of the lens.
ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06,
ELPLM07, ELPLL07
Date & Time: Make system time settings for the projector.
s "Setting the Time" p.41
Lens Calibration: Acquires the information of the lens
installed on the projector.
List of Functions
135
To Next Page
Loading...
Need help?
General
Weight and Dimensions
