Submenu Function
A/V Settings
A/V Output: Set this to Always On if you want to output
audio and images to an external device even when the
projector is in standby status.
Monitor Out: Select the image source output to an external
monitor when the projector is in standby status. When set
to Auto, analog RGB signals from the Computer port or the
BNC port are output depending on which source was
selected when the projector was turned off.
Audio Settings: Performs the following audio related
settings.
• Audio Output: Select the audio to be output when
projecting images from the Computer port, BNC port, or
DVI-D port. When set to Auto, audio is output from the
audio input port corresponding to each image input port.
s "Connecting Equipment" p.45
• HDMI Audio Output: Select the audio source when
projecting images from the HDMI port. If you select
HDMI, audio for the image is output as it is. If you select
Audio3, audio is output from the Audio3 port.
Standby Mode
If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
• Monitor and control the projector over a network.
• Output audio and images to an external device. (Only
when A/V Output is set to Always On.)
• Communication from the HDBaseT port is enabled. (Only
when Control Communications is set to On.)
a
When monitoring or controlling the pro-
jector using wireless LAN, set Connection
Mode to Advanced.
s Network - Wireless LAN - Connection
Mode p.140
Submenu Function
HDBaseT
Control Communications (This cannot be set when Extron
XTP is set to On.) When set to On, Ethernet
communication, serial communication, and the wired
remote control through the HDBaseT Transmitter connected
to the HDBaseT port are all enabled.
Extron XTP: Set to On when you connect the Extron XTP
transmitter or switcher to the HDBaseT port. See the
following Extron Web site for more details on the XTP
system.
http://www.extron.com/
a
• When Control Communications or Ex-
tron XTP is set to On, Standby Mode is
automatically set to Communication On.
• When Control Communications or Ex-
tron XTP is On, the projector's LAN
port, RS-232 port, and Remote port are
disabled.
• When Extron XTP is set to On, the fan
may rotate in standby mode but this is
not abnormal.
Color Calibra
tion
Start Auto Adjustment: Automatically adjusts the color
tone for the whole screen.
s "Color Calibration" p.188
Undo: Undoes the auto adjustment.
Redo: Redoes the auto adjustment.
Color Uniformity: Adjusts the color tone balance for the
whole screen.
s "Color Uniformity" p.191
Reset: You can reset all adjustment values for Color
Calibration to their default values.
List of Functions
136
To Next Page
Loading...
Need help?
General
Weight and Dimensions
