Attention
• Make sure you secure the following space around the projector so as not to
block the air exhaust vent and the air intake vent.
• When setting up multiple projectors, make sure there is a gap of at least
50 cm between the projectors. Also, make sure that the heat from the air
exhaust vent does not go into the air intake vent.
• Do not use two projectors at the same time when stacking two projectors
directly on top of each other. Install the projector so that there is no danger
that it will fall.
Attention
• Use commercially available M6 screws (up to a depth of 12 mm) to fix the
projector's ceiling mount fixing points and the mount at four points.
• When installing the projector with the air intake vent facing down, make sure
there is a gap of at least 10 cm between the projector and the floor and so
on. Make sure there is a gap of 500 x 200 mm for the base so that the air
intake vent is not blocked.
a
• We recommend setting the focus, zoom, and lens shift at least 20
minutes after you start the projection, because images are not stable
right after turning on the projector.
• When adjusting the image height with the vertical lens shift, adjust
by moving the image from the bottom to the top. If it is adjusted
from the top to the bottom, the image position may move down
slightly after adjusting.
Safety Warning and Cautions
5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
