Epson EB-L260F User Manual

251
Maintaining and Transporting the Projector
Follow the instructions in these sections to maintain your projector and transport it from place to place.
Projector Maintenance
Air Filter and Vent Maintenance
Replacing the Remote Control Batteries
Updating the Firmware
Transporting the Projector
Projector Maintenance
Your projector needs little maintenance to keep working at its best.
You may need to clean the lens periodically, and clean the air filter and air vents to prevent the projector
from overheating due to blocked ventilation.
The only parts you should replace are the air filter and remote control batteries. If any other part needs
replacing, contact Epson or an authorized Epson servicer.
This projector uses a sealed laser light source which does not need servicing and cannot be replaced.
Warning: Before cleaning any part of the projector, turn it off, unplug the power cord, and let it cool
down. Never open any cover on the projector, except as specifically explained in this manual.
Dangerous electrical voltages in the projector can injure you severely.
Warning: Do not try to service this product yourself, except as specifically explained in this manual.
Refer all other servicing to Epson qualified servicers.
Cleaning the Lens
Cleaning the Projector Case
Parent topic: Maintaining and Transporting the Projector
Cleaning the Lens
Clean the projector's lens periodically, or whenever you notice dust or smudges on the surface.
• To remove dust or smudges, gently wipe the lens with lens-cleaning paper.

Epson EB-L260F Specifications

General

Heat dissipation	884 BTU/h
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Vertical scan range	192 - 240 Hz
Projection technology	3LCD
Contrast ratio (typical)	2500000:1
Screen size compatibility	31 - 310 \
Projection distance (wide)	0.9 - 9.1 m
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	30 °
Projector brightness (economic mode)	3200 ANSI lumens
Light source type	Laser
Service life of light source	20000 h
Service life of light source (economic mode)	30000 h
Offset	1000 %
Throw ratio	1.32 - 2.12:1
Zoom capability	Yes
Focal length range	18.2 - 29.1 mm
Aperture range (F-F)	1.51 - 1.77
Serial interface type	RS-232C
USB 2.0 ports quantity	2
VGA (D-Sub) ports quantity	3
USB 2.0 Type-A ports quantity	1
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Noise level	37 dB
Projection modes	Ceiling, Front
Noise level (economic mode)	27 dB
Placement	Ceiling, Desktop, Floor, Wall
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Video color modes	Blackboard, DICOM simulation mode, Dynamic, Multi-projection, Presentation, sRGB
RMS rated power	16 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	260 W
Power consumption (standby)	0.5 W
Power consumption (typical)	199 W
Power consumption (economy mode)	144 W
Storage temperature (T-T)	-10 - 60 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Cables included	HDMI, Power
Bundled software	Epson Creative Projection, EasyMP Multi PC Projection, Epson Projector Content Manager, Epson Projector Management
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	299 mm
Width	325 mm
Height	90 mm
Weight	4200 g