Epson EB-L260F User Manual

301
Parent topic: Notices
FCC Compliance Statement
For United States Users
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio and television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC
Certification or Declaration of this device and may cause interference levels which exceed the limits
established by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If this equipment has more than one interface connector, do
not leave cables connected to unused interfaces. Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
For Canadian Users
CAN ICES-003(B)/NMB-003(B)
Parent topic: Notices

Epson EB-L260F Specifications

General

Heat dissipation	884 BTU/h
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Vertical scan range	192 - 240 Hz
Projection technology	3LCD
Contrast ratio (typical)	2500000:1
Screen size compatibility	31 - 310 \
Projection distance (wide)	0.9 - 9.1 m
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	30 °
Projector brightness (economic mode)	3200 ANSI lumens
Light source type	Laser
Service life of light source	20000 h
Service life of light source (economic mode)	30000 h
Offset	1000 %
Throw ratio	1.32 - 2.12:1
Zoom capability	Yes
Focal length range	18.2 - 29.1 mm
Aperture range (F-F)	1.51 - 1.77
Serial interface type	RS-232C
USB 2.0 ports quantity	2
VGA (D-Sub) ports quantity	3
USB 2.0 Type-A ports quantity	1
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Noise level	37 dB
Projection modes	Ceiling, Front
Noise level (economic mode)	27 dB
Placement	Ceiling, Desktop, Floor, Wall
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Video color modes	Blackboard, DICOM simulation mode, Dynamic, Multi-projection, Presentation, sRGB
RMS rated power	16 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	260 W
Power consumption (standby)	0.5 W
Power consumption (typical)	199 W
Power consumption (economy mode)	144 W
Storage temperature (T-T)	-10 - 60 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Cables included	HDMI, Power
Bundled software	Epson Creative Projection, EasyMP Multi PC Projection, Epson Projector Content Manager, Epson Projector Management
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	299 mm
Width	325 mm
Height	90 mm
Weight	4200 g