Epson EB-L260F User Manual

253
Damage due to the failure to properly maintain the projector or its filter may not be covered by the
projector's Limited Warranty.
Cleaning the Air Filter and Vents
Replacing the Air Filter
Parent topic: Maintaining and Transporting the Projector
Cleaning the Air Filter and Vents
Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them.
Note: It is recommended that you clean these parts over a 20000-hour period. Clean them more often
than this if you use the projector in a environment that is dustier than expected.
1. Turn off the projector and unplug the power cord.
2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in
water or use any detergent or solvent to clean it.
Caution: Do not use canned air. The gases may leave a flammable residue or push dust and debris
into the projector's optics or other sensitive areas.
3. If dust is difficult to remove or the air filter is damaged, replace the air filter.
Parent topic: Air Filter and Vent Maintenance
Related tasks
Turning Off the Projector

Epson EB-L260F Specifications

General

Heat dissipation	884 BTU/h
Number of colors	1.07 billion colors
Native aspect ratio	16:9
Vertical scan range	192 - 240 Hz
Projection technology	3LCD
Contrast ratio (typical)	2500000:1
Screen size compatibility	31 - 310 \
Projection distance (wide)	0.9 - 9.1 m
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	30 °
Projector brightness (economic mode)	3200 ANSI lumens
Light source type	Laser
Service life of light source	20000 h
Service life of light source (economic mode)	30000 h
Offset	1000 %
Throw ratio	1.32 - 2.12:1
Zoom capability	Yes
Focal length range	18.2 - 29.1 mm
Aperture range (F-F)	1.51 - 1.77
Serial interface type	RS-232C
USB 2.0 ports quantity	2
VGA (D-Sub) ports quantity	3
USB 2.0 Type-A ports quantity	1
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Noise level	37 dB
Projection modes	Ceiling, Front
Noise level (economic mode)	27 dB
Placement	Ceiling, Desktop, Floor, Wall
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Video color modes	Blackboard, DICOM simulation mode, Dynamic, Multi-projection, Presentation, sRGB
RMS rated power	16 W
Power source	AC
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	260 W
Power consumption (standby)	0.5 W
Power consumption (typical)	199 W
Power consumption (economy mode)	144 W
Storage temperature (T-T)	-10 - 60 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Cables included	HDMI, Power
Bundled software	Epson Creative Projection, EasyMP Multi PC Projection, Epson Projector Content Manager, Epson Projector Management
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	299 mm
Width	325 mm
Height	90 mm
Weight	4200 g