293
• When turning on the projector at a distance using the remote control, make sure there is no one
looking into the lens.
• Do not place any flammable objects in front of the projector lens, otherwise, a fire may occur.
• Do not touch the lens with bare hands.
• Do not place the projector on an unstable cart, stand, or table or on a surface that is unable to support
its weight. Otherwise, it could fall or topple causing an accident and injury.
• When installing or adjusting a ceiling or wall mount, do not use adhesives to prevent the screws from
loosening and do not use oils or lubricants. This may cause the projector case to crack and the
projector to fall from its ceiling mount. This could cause serious injury to anyone under the mount and
could damage the projector.
• Do not install the projector in locations exposed to high humidity and dust, such as on a kitchen
counter, in the kitchen, or near a humidifier, or in locations exposed to oil smoke or steam. Doing so
could cause fire or electric shock. In addition, the oil content could cause the projector’s outer case to
deteriorate and could cause the projector to fall off from the ceiling where it is suspended.
Examples of environments that could cause the projector to fall due to case deterioration:
• Locations subject to excessive smoke or airborne oil particles, such as factories or kitchens
• Locations containing volatile solvents or chemicals, such as factories or laboratories
• Locations where the projector could be subjected to detergents or chemicals, such as factories or
kitchens
• Locations in which aroma oils are often used, such as relaxation rooms
• Near devices that produce excessive smoke, airborne oil particles, or foam at events
• Locations where the projector could be subjected to ultraviolet rays, such as a sunny room
• Locations near humidifiers
• Do not use the projector near water, sources of heat, high-voltage electrical wires, or sources of
magnetic fields.
• Do not use the device near any medical equipment or equipment that is automatically controlled, such
as automatic doors or fire alarms. Electromagnetic interference from the device may cause such
equipment to malfunction and cause an accident.
• Use the type of power source indicated on the projector. Use of a different power source may result in
fire or electric shock. If you are not sure of the power available, consult your dealer or power company.
• Place the projector near a wall outlet where the plug can be easily unplugged.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
