Reflecting saved settings to other projectors
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the computer's USB port to the projector's USB-B port
with a USB cable.
c
While holding down the [Menu] button on the remote control or
the control panel, connect the power cord to the projector.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power: Blue - On / Status: Blue - On / Lamp: Orange - On / Temp: Orange - On
The projector is recognized as a removable disk by the computer.
Performing Batch Setup for Multiple Projectors
101
To Next Page
Loading...
