q
• If Password Protect is already activated, you must enter the
Password.
If the Password is entered correctly, the Password Protect setting
menu is displayed. s "Entering the Password" p.38
• When the Password is set, stick the supplied Password protect
sticker in a visible position on the projector as a further theft
deterrent.
(The Password protect sticker is not supplied with EB-X92/S92.)
B
Turn on "Power On Protect".
(1) Select Power On Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
C
Turn on "User's Logo Protect".
(1) Select User's Logo Protect, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
D
Set the Password.
(1) Select Password, and then press the [Enter] button.
(2) The message "Change the password?" is displayed, select Yes and then
press the [Enter] button. The default setting for the Password is "0000".
Change this to your own desired Password. If you select No, the screen
shown in step 1 is displayed again.
(3) While holding down the [Num] button, enter a four digit number using the
numeric buttons. The number entered is displayed as "* * * *". When you
enter the fourth digit, the confirmation screen is displayed.
Remote Control
(4) Re-enter the Password.
"Password accepted." is displayed.
If you enter the Password incorrectly, a message is displayed prompting you
to re-enter the password.
Entering the Password
When the Password entry screen is displayed, enter the Password using the
numeric buttons on the Remote Control.
Procedure
While holding down the [Num] button, enter the Password by
pressing the numeric buttons.
When you enter the correct Password, projection begins.
Security Functions
38
To Next Page
Loading...
Need help?
General
Weight and Dimensions
