You can monitor and control the projector from a computer, via USB. This
is done by connecting the projector and the computer with a USB cable,
and entering communication commands (ESC/VP21 commands).
Before You Begin
To monitor and control the projector with ESC/VP21 commands, the
following preparations must be carried out.
Procedure
A
Install the USB communication driver (EPSON USB-COM Driver)
to your computer. For information about the EPSON USB-COM
Driver, contact your local dealer or the nearest address
provided in the Support and Service Guide.
s Epson Projector
Contact List
B
From the projector's Configuration menu, set "Extended" - "USB
Type B" to "Wireless Mouse" or "Page Up/Down".
C
Similarly, set "Link 21L" to "On" from Extended menu.
D
Connect the computer's USB port to the projector's USB(TypeB)
port with a USB cable.
From second time on, start from step two.
Command List
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
Item Command
Power ON/OFF On PWR ON
Off PWR OFF
Signal selection Computer Auto SOURCE 1F
RGB SOURCE 11
HDMI (EB-W10/X10 only) SOURCE 30
Video SOURCE 41
S-Video SOURCE 42
USB Display SOURCE 51
USB (EB-W10/X10 only) SOURCE 52
A/V Mute On/Off On MUTE ON
Off MUTE OFF
A/V Mute selection Black MSEL 00
Blue MSEL 01
Logo MSEL 02
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
Monitoring and Controlling the Projector Using a Computer (ESC/VP21 Commands)
88
To Next Page
Loading...
Need help?
General
Weight and Dimensions
