Removing USB devices
After finishing projecting, remove the USB device from the projector's
USB(TypeA) port.
For digital cameras, hard disks, and so on, turn off the power to the device
and then remove.
Starting and Ending a Slideshow
Starting a slideshow
Procedure
A
Switch the projected image to USB. s p.22
B
Connect the USB storage device or the digital camera to the
projector.
s p.41
The Slideshow starts and displays the file list screen.
Ending a slideshow
Procedure
To end a Slideshow, remove the connected USB device from the projector.
s "Removing USB devices" p.42
q
• You can insert a memory card into a USB card reader and connect
it to the projector. However, it may not be possible to use some
commercially available USB card readers with the projector.
• If the following screen (Select drive screen) appears, select the drive
you want to use by pressing the [ ] and [ ] buttons on the
remote control, then press the Enter button.
• To display the Select drive screen, set the cursor to Select drive on
the top of the file list screen and press the Enter button.
• Up to four media types can be recognized at one time by the
projector.
Slideshow Basic Operations
This section explains the procedure for playing back and projecting images
in Slideshow.
Although the following steps are explained based on the Remote Control,
you can perform the same operations from the projector's Control panel.
Procedure
A
Press the [ ], [ ], [ ], and [ ] buttons to set the
cursor on the file or folder you want to operate.
Making a Presentation with a Slideshow (EB-W10/X10 only)
42
To Next Page
Loading...
Need help?
General
Weight and Dimensions
