Appendix
122
Settings - Standby Mode - Communication On
s p.91
*4
For EH-LS10000, the HDMI1 port supports HDCP 2.2, and the HDMI2 port supports HDCP 1.4. For EH-LS9600W,
both ports support HDCP 1.4.
Angle of tilt
If you use the projector tilted at an angle of more than 3°, it could be dam-
aged or cause an accident.
ESC/VP21 commands
Use of ESC/VP21 enables control of the projector from an external device. For more details, see the following
Web site.
http://www.epson.com
RS-232C cable layouts
•
Connector shape: D-sub 9-pin (male)
•
Projector input port name: RS-232C
•
Signal name:
Signal Name Function
GND Signal wire ground
TD Transmit data
RD Receive data
<At the projector> <At the computer>
<At the projector> (PC serial cable) <At the computer>
•
Communications protocol
Default baud rate setting: 9600 bps
Data length: 8 bit
Parity: None
Stop-bit: 1 bit
Flow control: None
To Next Page
Loading...
