Setting Image Quality
49
a
Press the button, select Image
- Dynamic Contrast from the
Configuration menu, and then press
the
button to confirm the
selection.
The Dynamic Contrast adjustment screen
is displayed.
c
For EH-LS10000, you can also
make settings by pressing the
button on the remote
control.
b
Use the buttons to
select the item, and then press the
button to confirm the selection.
c
Press the button to exit the
menu.
Frame Interpolation
This setting compares the current and previous frames, and then creates a frame between them to to create
smooth images even for movies with a quick frame rate.
You can select the level of interpolation from Low, Normal, or High.
a
Press the button.
EH-LS10000 EH-LS9600W
c
•
You can make settings from the
Configuration menu.
s Signal -
Frame Interpolation p.88
•
This cannot be set when Image
Processing is set to Fast in the
Signal menu.
s Signal -
Advanced - Image
Processing p.88
•
This cannot be set when a
computer image signal is being
input.
•
When projecting 3D images and
when Super-resolution/4K from
the Signal menu is set to 4K, this
setting is only available for
1080p/24 Hz signals.
s Signal -
Super-resolution/4K p.88
b
Use the buttons to
select the item, and then press the
button to confirm the selection.
c
•
If you notice any distortion after
changing the setting, set it to Off.
•
When a 4K image signal is being
input, this setting is fixed at Off,
and Low, Normal, and High
cannot be set.
c
Press the button to exit the
menu.
To Next Page
Loading...
