Useful Functions
84
Button Function
c
Changes to the image from each input port. s p.34
(The WiHD button is only available for EH-LS9600W.)
d
Temporarily hides or shows the image. s p.36
e
Changes between 2D and 3D images. s p.39
f
Loads the lens position. s p.63
Using the Mail Notification Function to Report Problems
When you set Mail Notification in the Configuration menu, notification messages are sent to the preset email
addresses when a problem or warning occurs with a projector. This will enable the operator to be notified of
problems with projectors even at locations away from the projectors.
s
Network - Mail - Mail
Notification p.96
c
•
Up to a maximum of three notification destinations (addresses) can be registered, and notification
messages can be sent to all three destinations at once.
•
If a projector develops a critical problem and suddenly stops working, it may not be able to send a
message notifying an operator of the problem.
•
If you set Standby Mode to Communication On, you can monitor the projector even if it is in standby
mode (when the power is off).
s Settings - Standby Mode p.91
Reading error notification mail
When the Mail Notification function is set to On and a problem or warning occurs in the projector, the
following email will be sent.
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has occurred
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message contents are listed below.
Message Contents Remedy
No-signal No signal No signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
To Next Page
Loading...
